New month new set of pieces!
First are some octagonal frames to use as simple windows or doors.
Next are a new set of Hinge bricks that print as one piece! Took a bit to figure out how to keep it structural while also not letting it wobble on the other axis. As a bonus I was able to have the center hinge have a stud on top as well as a peg hole on the bottom. I’m unsure if or how I’d shrink this down to a plate-sized hinge, but I’m glad we got this all figured out!
And finally is the new chain piece. I’ll probably add a few more sizes of chain later. This is also single-piece, and has a lot of surface area to stick to your heat-plate. I still use glue, but be aware if you do you may need to grab pliers and a wedge, loosen each middle section of the links, and pry it all off.
I think current focus is gonna be on having more basic pieces be added. Planning on variants of plates with smooth sections for roads, possibly some more hinge type pieces, lots more frames and larger pieces, and then probably a few more slab designs.